K&L Supply
FLYWHEEL PULLER BOLT 14mm x 1.5mm
FLYWHEEL PULLER BOLT 14mm x 1.5mm
Couldn't load pickup availability
14mm x 1.50 Flywheel Puller STUD RH Male, Magneto K&L 00-0829
HONDA
Honda ATC200 1981 - 1985
Honda ATC200E 1981 - 2004
Honda ATC200M 1984 - 1985
Honda ATC200S 1984 - 1986
Honda ATC200X 1981 - 2011
Honda CB125S 1973 - 1985
Honda TRX125 1985 - 1988
Honda TRX200 1984
Honda XL125 1970 - 1983
Honda XL125S 1979 - 1985
Honda XL185S 1979 - 1983
Honda XL200R 1983 - 1984
Honda XR185 1979
Honda XR200 1980 - 1984
Honda XR200R 1980 - 2003
- All pullers made to precise standards equal to factory original tools or better. Each tool and bolts are black oxide plated for rust protection.
- Tool hardness is softer than the motorcycle part to prevent damage to expensive crankshafts and flywheels. 5/8in. fine thread bolts used in all pullers.
Tips on use.
- Make sure the flywheel thread is clean of dirt and not damaged before screwing the puller in.
- Use copper grease on the puller threads, for long life.
- Make sure the puller is fully screwed into the flywheel.
- After tightening use a hammer on the centre and tap to jolt free [not always need].
- If using old flywheel pullers make sure the threads are in good condition before use to avoid damage to flywheel.
Part No. 00-092 (oro2u.com).
Cross Reference Numbers Only:
MP19
Share
